And again, inform employees about what the locks are for. You could also use padlocks to keep "off limit" equipment from being used, but make sure the locks you use can’t be mistaken as lockout locks. This method gives employees an instruction, and to be most effective you should inform your workers that this is how you’re going to identify equipment that isn’t supposed to be used. The authorized person will identify the machine, equipment, or process that requires lockout, which sources of energy are present and must be controlled, and what lockout device will be used. A personal danger tag should be attached to an isolator in a visible position whenever the isolator is used to lock out an energy source to allow work to be done. This isn’t the same as following a tagout procedure – the tag is on the controls and not the energy isolating devices, and the tag doesn’t include a tagout warning statement. General steps of a lockout/tag out procedure include: 1. You could attach a tag such as "Do not use without authorization" or something similar onto the machine’s controls to show that you don’t want employees to operate that machine.
Dismantle it so that it isn’t hooked up to any energy anymore and it’s completely unable to be operated. Communication with all employees in the area C. To keep out-of-service machinery from being used, you might consider physically disconnecting it from its energy supplies. Quiz Lock Out Tag Out Which of the following is important and must take place at the beginning and at the end of every lockout/tagout/tryout situation A. The lockout/tagout standard says that you can’t use lockout/tagout equipment for any other purpose, so if you aren’t actually doing repairs or servicing work on this equipment, you shouldn’t use lock out/tag out equipment on it. Its purpose is to ensure forklifts and other dangerous pieces of equipment are shut down and can’t be restarted until they’re once again safe to operate. The lockout/tagout standard doesn’t apply when you "decommission" equipment or put machines "out of service." The main concern is probably that someone would try to start a machine that you don’t want to run anymore, for whatever reasons. Lockout tagout (LOTO) is a lock and tag safety procedure used in industrial and research and development (R&D) settings. Our deep knowledge of federal and state agencies is built on a strong foundation of 70+ years of regulatory compliance experience. More than one energy source (electrical, mechanical, hydraulic, thermal, and chemical) may be present with a single piece of equipment. You can trust our expertise across subjects relating to labor, transportation, environmental, and worker safety. devices apply to the equipment to be locked or tagged out.
0 kommentar(er)
